In this video I build the Dipole that we designed and printed from TinkerCad.
This video is a little long but I didn’t want to leave much out for the new Hams that may have never built an antenna! I will list parts below that I used
The first video on the design, https://www.youtube.com/watch?v=a_9-txQ-XNs
As an Amazon Affiliate I may ear a commission on merchandise purchased at no cost to the customer.
Helping Hands Soldering Station, https://amzn.to/3MaaoGw
Digital Soldering Station , https://amzn.to/4bT7Y9F
BNTECHGO 18 Gauge Silicone Wire, https://amzn.to/4a12hEb
Jumper coax, https://amzn.to/4tbnrbB
Heat shrink pick your sizes, https://amzn.to/3LDwxNr
#8 Bolt Ring Terminals,, https://amzn.to/49HyGRi
300W Mini Heat Gun, https://amzn.to/3LCY41t
Small plastic carabiner, https://amzn.to/4a1X4vU
370 Pieces M4 screw kit, https://amzn.to/3LY4I2n
#antenna , #dipole , #tinkercad ,
.