Xiegu G90 and FT8 on Raspberry Pi – Ham Radio – TheSmokinApe
In this video we show how to set up / configure FT-8 on the Xiegu G90 HF radio using a Raspberry Pi. Please leave any; comments, suggestions or recommendations below.
Support TheSmokinApe Channel on Patreon Here: https://www.patreon.com/TheSmokinApe
Links to products in the video: https://www.amazon.com/shop/TheSmokinApe
Spare G90 CAT Control Cable: https://amz.run/3W6P
Sabrent USB Sound Card: https://amz.run/3W6S
Get your G90 Here: https://amz.run/3NTB
As an Amazon Associate I earn from qualifying purchases.
How to Install HamPi on Raspberry Pi 4b: https://youtu.be/vPVHxITxqpw
Check out my Xiegu G90 Playlist Here: https://www.youtube.com/watch?v=4f_HHExV6-4&list=PLm8ROkpFeqor_gijvPi24GsdKg1WLM93a
Check out my HAM Radio, Scanner, Walkie Talkie Playlist: https://www.youtube.com/playlist?list=PLm8ROkpFeqoolh8jN6HRo7xnLC9op6AkM
If you liked this video you can see more like it here:
http://www.youtube.com/TheSmokinApe
You can also follow me on Twitter and Instagram:
Tweets by TheSmokinApe
http://www.instagram.com/TheSmokinApe
G90 Settings:
Turn of Speech Compression – [CMP] Button
Set AGC to Off – [AGC] Button (AGC–)
Mode to USB – Use Mode Button
AUX In to Line – [FUNC] then [POW] set to Line, [POW] will set Gain (10)
AUX In Volume – Press and hold [FUNC], press [VM] Button until Opt 5, Tuning Knob to set, [CMP] to save, [AGC] to exit
AUX Out Volume – Press and hold [FUNC], press [VM] Button until Opt 6, Tuning Knob to set, [CMP] to save, [AGC] to exit
I’m using CAT for PTT Control, so we’re not setting up VOX.